Capillary tube selection

The point 2 at which the first gas bubble appears is called the bubble point. Approximate analytic solution of adiabatic capillary tube. In certain cases, the best possible choice of capillary diameter and length might deviate remarkably from this calculated result.

Uploader: Kagall
Date Added: 8 February 2005
File Size: 18.80 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 78640
Price: Free* [*Free Regsitration Required]





But ounce the capillary. The idea is to find the smallest possible tube without getting choked flow.

Capillary Tube Selection | Nidec-Secop

Next, Yilmaz and Unal Of course, this is just an estimate ca;illary it is based on theory only but it does give a good starting guess. Wijaya experimental data is better correlated with the Yil maz-Unal method.

Empirical Correlations for t he modeling of Ra flow. Here are the instructions how to enable JavaScript in your web browser. Would become worn or that the capillary tube has no moving parts that need to be changed, because the small diameter of the appropriate length is designed to carry on the refrigeration load is a pipe made of copper.

As you reduce the suction pressure, you will eventually reach a point when a further increase in mass flow is impossible.

Thus the pressure is equal on both circuits balancing event and the compressor capillaey not met with again from a large pressure load while. Various friction factor models found in the literature.

DanCap | Capillary Tube Selection in Refrigeration | Danfoss

The corresponding saturation inlet temperature at 15 bar is Simple selection method for capillaries derived from physical flow conditions. Comparison of predicted mass flow rates with dat seleftion measured by.

One is the explicit function of capillary tube length. There are essentially two tasks.

Sometimes, an intermediate diameter is clear that better results eg. American Institute of Chemical Eng. The present model, tested for HCFC22 and its alternatives Ra, Ra, Ra, Ra and Rc, is found to agree reasonably well with experimental data in open literature. Numerical and e xperimental st udies on adiabatic and non-adiabatic. Based on the approximate analytic solutions developed by the author, influences of geometrical parameters inner diameter and length and inlet operating parameters pressure, subcooling or quality on the mass flow rate through an adiabatic capillary tube have been intensively studied in this Intensive parameter analysis of adiabatic capillary tube using approximate analytic solution.

If the system becomes unbalanced, some vapour uncondensed refrigerant enters the capillary tube. The present model can be used also to investigate the effect of varying mass flow rates, inner diameters and.

Table 1 summarizes different friction factor correlations found in. Refrigerationvol 22, no 8: Get to know us.

Capillary Tube and Selection

In the present study the stocker friction factor m odel is. Bittle and Pate The mass flow determined by the pr esent analytical model are compared with.

Its seleection my first time to go to see tesisat. The comparison of the present study results with those of Melo's and.

Choked flow occurs when further decrease in outlet pre ssure does not result in an increase in t he mass flow. Mass flow rate for the reference capillary tube. Essentially, it is a very small bore tube that is selected such that the frictional pressure drop equals the required pressure drop between the condensing and capilpary pressures.

About the Author: Mazujar

1 Comments

  1. I am sorry, that I interrupt you, but it is necessary for me little bit more information.

Leave a Reply

Your email address will not be published. Required fields are marked *